15mm.

In rear floor. 35 mm.

In fire wall, right bottom. 42 mm. Passage holes in rear pillars,inside. 42 mm. Summer ventilation. 42 mm. Opening in partition panel,left d=42,0 mm. 42 mm. Outer left rear rear-end floor. 42 MM.

Oblong holes in side member. Mounting in transit;at side members rear left and right 43 x 27 mm.

Apparatus case. 6.5mm. Paint run-off holes in rear lid 6,5 mm. 6.5mm. Sliding roof hose passage. 6.5mm. To mount warning triangle. 6.5mm. At central inside part below windshield. 6.5mm.

Insulation mounting. 8.5 mm. Rear seat framework. 8.5 mm. Engine cross member 10mm. 8.5 mm. Damping to partition wall rearwall. 8.5 mm. Lining to backrest. 8.5 mm. Tunnel,front. 8.5 mm. At covering. 8.5 mm. To plug the mounting holes in the engine support 10mm. 8.5 mm. Left. 8.5 mm.

Workshop lifting jack take-up device in side member,bottom 28mm. Mount workshop jack in longitudinal member, front left 30mm. Take-up device lock at floor, hard-rubber buffer used for jack 28mm. Workshop vehicle lifter fixture in side member, bottom left 28mm.

Rear lid stop to rear body panel, bottom. At rear lid,left and right. To plug the hole in front side member end piece. Fuel filler neck.

Panelling to floor.

Entrance water drain. Left side member,outside. Side member, bottom outside. Inside rear pillar 32 mm. Main floor,left and right 31 mm. Side panel water drain left 32 mm.

Holder on left A-pillar.

In floor below rear seat bench 40 mm. Main floor 40 mm.

Cable passage,partition panel,top left.

Cable passage,partition panel, bottom right.

Partition panel,left and right. Used for brake lines.

To a b s & a s r lines. Partition panel,left.

To lock safety belt mounting holes. Cross member below rear seat 15 - 17,5 mm. Hitching mechanism to side member.